Of course. Safety comes first. If the system is active but you suddenly need to avoid something due to an obstacle (e.g., a tree), just grab and turn the wheel with a firm movement. The controller detects the increase in power consumption and immediately disengages the automatic steering. The sensitivity (how much force is needed […]
The robust, levered Delphi sensor included in the kit is the best and most universal choice; 95% of users use this. It is mounted on the front axle to measure the wheels’ turn. There is also a linear sensor, but its installation next to the cylinders requires much more custom metalwork. The Kyocera sensor can […]
The tablet, control box, and GPS antenna can be moved in moments. However, we do not recommend moving the steering motor and wheel angle sensor (WAS) on a daily basis because it requires recalibration. If you would use the system interchangeably on two machines, the smartest (and most popular) solution is to buy a fixed […]
Geared Kit: This is the cheapest solution. A separate electric motor must be fixed to the steering column, which drives a gear ring mounted on the factory steering wheel. Its installation requires a bit more DIY work. Its setup is slightly more difficult. Direct Drive Kit: This is currently the most popular choice. The tractor’s […]
Yes! Hydraulic control gives the most “”factory”” feel to the steering. In terms of accuracy, it is very similar to other steering solutions, but it is much more cumbersome to set up. Our control box and hydraulic-ready wiring harness are perfectly suitable for this. The system can control both Open Center (OC) and Load Sensing […]
To ensure you select the correct adapter, the most reliable method is to remove the steering wheel and measure the diameter of the splined shaft, as shown in the image.
In most cases, the spline count is 36; therefore, the diameter is the determining factor. Based on our experience, dimensions are consistent across certain brands.
Models for which the data in the table below are highly reliable:
John Deere and newer machines from the CNH Group: A+
Claas and Massey Ferguson: N
| Adapter Model | Tractor Brands & Models | Adapters teeth no. | Adapters size |
|---|---|---|---|
|
A+ |
CNH group newer:
|
36 |
21.8-22.1 |
|
D |
|
36 |
20.4 |
|
K |
|
36 |
17.8 |
|
N |
|
36 |
15.8 |
|
B |
|
36 |
18.2 |
|
W |
|
36 |
18.5 |
|
F |
|
single key |
24.5 |
|
NH40 |
older ones:
|
40 |
17.7 |
|
T |
|
18 |
15.45 |
|
G |
RARE:
|
36 |
15.6 |
|
C |
|
single key (conical) |
23.33-25.4 |
|
BENZ- 72S |
|
72 |
23.5 |
Add an external 4G router to your kit if:
